Product reviews for Streamlight Remote Retaining Clip for remote switches

Worked well, no issues as advertised. Would order it again. Great for AR15 Rail.

Exactly what I needed for my streamlight

Awesome! Holds my pressure switch right where I want it, and not near as expensive as a lot of others. Put your pressure switch on 2 of these and you'll be just fine.

The light switch slides forward and back bdut will definitely not pop out

Works great

Not much to review, they work.

Hold great, even when Runnin' N Gunnin! Worth getting.

Total crap. Broke one clip while assembling, I cant imagine it would have stood up to anything very strenuous.

Easy to install and very secure. A very simple solution to mounting the pressure switch. I was expecting them to be black but the color is a dark grey. I have another older set that are black. I'm sure this is just a normal variation from one lot to another.

This works great with my Streamlight Pro Tac pressure pad.

Fantastic Product, however they do not fit Surefire light pads.

Perfect for Streamlight pressure switches.

For what it does, and being there are none out there like it, it is a great product. It's simple, not idiot proof, but to hold a plate switch without taping it down, what more could you ask for. The other styles or types were just too expensive, and I am outraged for what they charge. This is designed to go over a rail, Ideally if I could make a rail that had a built in area for a switch, the profile would be much more smaller. This is a great solution to a very simple concept.

Does not fit all switches.

They do what they're supposed to do.

Received item that was described but it didn't accommodate what I had planned.

Works like it should

It works good. Used in HK-UMP rail and DD-m4 rail

Do the job!

Didn't fit on the rail of any of my rifles. I didn't feel like going through the hassle of returning them. Will give to a friend if they fit their rifle.

Waste of money

Very well made, I didn't need them they came with switch. But will use them on another AR.

They work on specific pressure pads so not all pads will fit but when they do it's nice and snug. Can help with cable management well. Putting it on the rails is quite tricky since you don't slide them on, but rather put them on the rail.

It did exactly what it was supposed to do. It's a flush fit between the rail and clip with enough room to accommodate my pressure switch. There are no lips to secure your switch to the clips though so that might be something to take into consideration. My switch came with velcro and two sided tape and these clips gave it a nice even platform to adhere to.

Beats having to use double sided tape.

easy to install. fit is tight and secure. ready for the revolution 🤘🏻