CMC93502 - Single Stage Traditional Curved Trigger Group Small Pin for your AR15 or AR10. This LE Model has 2-4lb break/weight point.

• Gunsmiths patented one piece assembly installs in minutes. Check for safe and proper function, you're done!
• Installation of the trigger group is quite simple insert the one piece assembly, install the supplied pins. No screws to adjust or worry about coming loose at the worst possible time.
• No cheap tricks or compromises Full-strength rocket wire springs for fast lock-time and reliable discharge with factory or military ammo.
• Tolerances of +/- .001" for all engagement surfaces. Hammer, trigger, disconnector and pins are made with the highest grade, hardest, longest-wearing materials available. The assembly is contained in a high-grade 410 stainless steel housing.
• Factory-tuned for a superior trigger pull with minimum take-up and over-travel. Typical quality we're famous for.
• Fits Mil-Spec receivers. Available for small or large center pin receiver holes.
• Not recommended for use in 5.45 x 39 .