CMC93501 - Single Stage Traditional Curved Trigger Group Small Pin for your AR15 or AR10. This model has 5-5.5lb break/weight point.

• Gunsmiths: patented one piece assembly installs in minutes. Check for safe and proper function, you're done!
• Installation of the trigger group is quite simple: insert the one piece assembly, install the supplied pins. No screws to adjust or worry about coming loose at the worst possible time.
• No cheap tricks or compromises: Full-strength rocket wire springs for fast lock-time and reliable discharge with factory or military ammo.
• Tolerances of +/- .001" for all engagement surfaces. Hammer, trigger, disconnector and pins are made with the highest grade, hardest, longest-wearing materials available. The assembly is contained in a high-grade 410 stainless steel housing.
• Factory-tuned for a superior trigger pull with minimum take-up and over-travel. Typical quality we're famous for.
• Fits Mil-Spec receivers. Available for small or large center pin receiver holes.
• Not recommended for use in 5.45 x 39 .